Home / Service Areas / Jay / Building Automation & Controls

Building Automation & Controls in Jay, NY.

Building automation and control systems for Jay properties: BAS field wiring, networked lighting control, occupancy and daylight sensing, scheduling, and the programming and commissioning that make it all actually work.

Request Service or call (518) 545-8864

Built Strong. Wired Right. Built Around the Builder Licensed & Insured Saratoga · Capital Region · North Country

Working in Jay

The covered-bridge town on the East Branch of the Ausable, with the hamlet green at its center and homes scattered from the river flats up into the Jay Mountain foothills. River-valley homesteads and camps, plenty of them older; flood-aware wiring and panel placement matter here.

Lodging and rental properties use controls operationally — turnover scenes, occupancy-based setback, and remote visibility between bookings.

What building automation covers

The control layer of a building: networked lighting control with occupancy sensing, daylight harvesting, and time-of-day scheduling. Building automation and management system field devices, controllers, and the wiring that connects them. HVAC control interfaces and equipment interlocks. Energy monitoring feeding data back so decisions are made from numbers rather than opinions.

On the wire side this is sensors, controllers, actuators, and communication trunks running protocols like BACnet, Modbus, and DALI. On the software side it is the sequences of operation, schedules, setpoints, and scenes that decide how the building behaves.

The full picture of this service — scope, process, and pricing approach — lives on our building automation & controls page. This page is the short version for Jay: we do this work here, we know the area, and the quote comes in writing.

What's included

Networked lighting control design, install, and programming
Occupancy, vacancy, and daylight-harvesting sensor commissioning
BAS / BMS field wiring, controllers, and device installation
HVAC control interfaces and equipment interlocks
Schedules, scenes, and sequences of operation documented

Get a Quote in Jay

Building Automation & Controls in Jay: your questions

Do you program the system or only wire it?

Both. We keep controls programming in house rather than subcontracting it, which is unusual for a regional electrical contractor and is the reason our systems get commissioned properly instead of merely energized.

Will lighting controls actually save money?

Yes, when they are commissioned honestly. Occupancy sensing and scheduling routinely cut lighting energy well beyond the LED savings alone. Systems that are installed but never tuned get overridden by occupants, and then they save nothing — which is why the commissioning matters more than the hardware.

Can you work with the system we already have?

Usually. We extend, repair, and reprogram existing lighting control and automation systems as often as we install new ones. Send us the make and model and we will tell you honestly whether it is worth extending or has reached the end of its useful life.

What happens when the internet goes down?

A properly designed system runs its schedules, scenes, and sensors locally — only remote access needs the internet. That distinction drives the systems we specify, and it is worth confirming on any system you are quoted.