Home / Service Areas / Keene & Keene Valley / Building Automation & Controls

Building Automation & Controls in Keene & Keene Valley, NY.

Building automation and control systems for Keene & Keene Valley properties: BAS field wiring, networked lighting control, occupancy and daylight sensing, scheduling, and the programming and commissioning that make it all actually work.

Request Service or call (518) 545-8864

Built Strong. Wired Right. Built Around the Builder Licensed & Insured Saratoga · Capital Region · North Country

Working in Keene & Keene Valley

The gateway to the High Peaks — Keene, Keene Valley, and St. Huberts along Route 73, where trailhead traffic meets a community of year-round homes and long-held family camps. Older farmhouses and camps up steep private drives; generator and service work here has to account for real winter access.

Lodging and rental properties use controls operationally — turnover scenes, occupancy-based setback, and remote visibility between bookings.

What building automation covers

The control layer of a building: networked lighting control with occupancy sensing, daylight harvesting, and time-of-day scheduling. Building automation and management system field devices, controllers, and the wiring that connects them. HVAC control interfaces and equipment interlocks. Energy monitoring feeding data back so decisions are made from numbers rather than opinions.

On the wire side this is sensors, controllers, actuators, and communication trunks running protocols like BACnet, Modbus, and DALI. On the software side it is the sequences of operation, schedules, setpoints, and scenes that decide how the building behaves.

The full picture of this service — scope, process, and pricing approach — lives on our building automation & controls page. This page is the short version for Keene & Keene Valley: we do this work here, we know the area, and the quote comes in writing.

What's included

Networked lighting control design, install, and programming
Occupancy, vacancy, and daylight-harvesting sensor commissioning
BAS / BMS field wiring, controllers, and device installation
HVAC control interfaces and equipment interlocks
Schedules, scenes, and sequences of operation documented

Get a Quote in Keene & Keene Valley

Building Automation & Controls in Keene & Keene Valley: your questions

What happens when the internet goes down?

A properly designed system runs its schedules, scenes, and sensors locally — only remote access needs the internet. That distinction drives the systems we specify, and it is worth confirming on any system you are quoted.

Do you handle code-required lighting controls?

Yes. New York’s energy code has specific lighting control requirements for commercial work, and they are a normal part of our scope on any project in Keene & Keene Valley — designed in, installed, and documented for the inspection.

Who maintains the system afterward?

You can, and we document it so you genuinely can. Many clients keep us on a maintenance agreement for schedule changes, seasonal retuning, and adding zones as the building changes.

Do you program the system or only wire it?

Both. We keep controls programming in house rather than subcontracting it, which is unusual for a regional electrical contractor and is the reason our systems get commissioned properly instead of merely energized.